[Table of Contents] [Previous Page] [Next Page]

10-3 GREASING

 

  • Be sure to use the designated grease. Using undesignated grease can cause parts damage.

  • Do not apply greasing to places other than those specified. Greasing to undesignated places can cause malfunctioning and the qualitative deterioration of parts.

    Once every 6 months, apply greasing to SWING Volume gear mesh portion, Swing Frame supportive Bearings, and Motor Gear mesh portion.

    Apply GREASE. For bearings, apply exclusively used grease.

     

    MOTOR GEAR MESH PORTION

     

    1. Take out the 4 screws and remove the upper cover.

    2. Locate inner metal safety shield, and loosen all four screws that secure shield to frame.

    Remove 2 of 4 screws and remove shield.

    3. After service is completed, be sure to replace safety shield and upper cover.

    4. By using the spray grease, be sure to apply grease only to the gear mesh portion.