[Table of Contents] [Previous Page] [Next Page]

11. COIN SELECTOR

 

HANDLING THE COIN JAM

If the coin is not rejected when the REJECT button is pressed, open the coin chute door and open the selector gate. After removing the jammed coin, put a normal coin check to see that the selector correctly functions.

 

CLEANING THE COIN SELECTOR

The coin selector should be cleaned once every 3 months. When cleaning, follow the procedure below:

1) Turn the power for the machine OFF. Open the coin chute door.

2) Open the gate and dust off by using a brush (made of wool, etc.).

3) Remove and clean smears by using a s cloth dipped in water or diluted chemi, detergent and then squeezed dry.

4) Remove the CRADLE.
When removing the retaining ring (E ring), be very careful so as not to bend the shaft.

5) Remove stain from the shaft and pillow portions by wiping off with a soft cloth, etc.

6) After wiping off as per 5) above, further apply a dry cloth, etc. to cause the coin selector to dry completely.

 

  • Never apply machine oil, etc. to the Coin Selector.

  • After cleaning the Coin Selector, insert a regular coin in the normal working status and ensure that the Selector correctly functions.

     

    COIN INSERTION TEST

    Once every month, when per the Coin SW Test, simultane check the following:

    Does the Coin Meter count satisfactorily?
    Does the coin drop into the Cashbox correctly?
    Is the coin rejected when inserted while keeping the Reject Button pressed down?