1) Tum power off.
2) Remove the SWING COVER from the front of the Rear Cabinet. Remove the 6 Truss Screws. (Photo 10. 1)
Facing the inside of the Cover, the SWING VOLUME is on the upper left side.
3) To move the Volume Bracket, loosen the
2 screws which secure the Volume Bracket.
4) Move the Volume Bracket, disengage the gear mesh and turn the volume shaft so that the D-cut portion of the Volume Shaft faces the Volume Bracket side as shown. (FIG. 10. 1 )
5) Have the gears mesh, fasten the 2 screws, and secure the Volume Bracket.
6) After making adjustments, be sure to perform volume setting in the Test mode. (9-1 1)
7) If the volume is malfunctioning, first disconnect the connector which is connected to the Volume, remove the 2 screws which secure the Volume Bracket, and remove the Volume Bracket together with the Volume as is attached.
8) Remove the gear from the Volume Shaft and replace the Volume.