MONITOR SERVICE
MONITOR SERVICE CAUTIONS
Before handling the monitors. be sure to read the following
explanations and comply with the caution/warning instructions
given below. Note that the caution/warning symbol marks and letters
are used in the instructions.
WARNING!
- When performing such work as installing and removing the
monitor, inserting and disconnecting the external connectors
to and from monitor interior and the monitor, be sure to disconnect
the power connector (plug) before starting the work. Proceeding
the work without following this instruction can cause electric
shock or malfunctioning.
- Using the monitor by converting it without obtaining a prior
permission is not allowed. SEGA shall not be liable for any malfunctioning
and accident caused by said conversion.
WARNING!
- FIG. 30.1: Primary side and Secondary side
The monitor's circuit which is divided into the Primary side
and Secondary side, is electrically isolated. Do not touch the
primary side, or do not touch both the primary side and the secondary
side simultaneously. Failing to observe the instruction can cause
electric shock and this is very dangerous. When making monitor
adjustments, use a nonconductive driver and make adjustment without
touching any part other than the Adjustment V. R. and knob. Also,
be sure not to cause a short-circuit to the Primary side and
Secondary side. If short- circuited, it can cause electric shock
or malfunctioning, which is very dangerous.
- FIG. 30.2: High-tension Voltage
Some of the parts inside monitor are subject to high-tension
voltage in excess of 20,000 volts and very dangerous. Therefore,
do not touch the monitor interior. Should soldering & paper
wastes, etc. be mixed in the monitor interior, turn the power
off so as not to cause malfunctioning or fire hazard.