[Table of Contents] [Previous Page] [Next Page]

SERVICE INFORMATION

BILLBOARD LAMPS REPLACEMENT
  1. Turn off the game at the power switch and unplug the Indy 500 Twin game.
  2. Remove the three screws along the front edge of the Billboard between the Billboard and the Race Leader Marquee.
  3. Tilt the Billboard top section open toward the rear, as shown in Figure 49.
  4. The lamps are located as shown in Figure 49.
  5. Replace the Billboard's fluorescent lamp with a 48 inch, 40 Watt fluorescent lamp.
  6. Replace the Race Leader spot light(s) by lifting the Lamp Lid(s) and replacing tne burned out bulb(s) witn 110V, 30 Watt incandescent spot lamps.
  7. Replace the Lamp Lid(s), if necessary.
  8. Tilt the Billboard top section back into place.
  9. Replace the three screws back into the front edge.

CAUTION!
Use caution when removing lamps, they may be very hot.