[Table of Contents] [Previous Page] [Next Page]

ACCELERATOR & BRAKE

In the test mode, if the ACCEL. & BRAKE V.R. value is not within the allowable range, an adjustment of V.R. installation position, or a replacement of V. R. is needed. Also, grease the Mechanism's shafts and sliding portions once every 3 months. When performing the above work, remove the 6 Hexagon Bolts and carefully draw the Unit (the weight of which is approximately 6 kg.) in the manner not to damage the wiring.

11 - 1 ADJUSTING AND REPLACING THE V.R.

Pull out the Unit, and ACCEL. & BRAKE Mechanism appears. The V. R. on the left-hand side of the Mechanism is for the ACCEL., and the V. R. on the right-hand side of the Mechanism is for the BRAKE. Check the V. R. values in the test mode. The appropriate value of each V.R. is as follows:

When released: When stepped on:
ACCEL. Under 30 H ---> Over C0H
BRAKE Under 30 H ---> Over C0H

Method of V. R. replacement

To replace the V. R., after taking off the connector from the V. R. to be replaced, take out the 2 screws which secure the V. R. Bracket, and remove the V. R. together with the bracket and gear. After the replacement, check the V. R. value variations in the test mode.