10. SHIFT LEVER
In the Test mode, if the SHIFT LEVER's SW can not be inputted
satisfactorily, replace the Switch. Apply greasing to the Mechanism's
sliding portion once every 3 months. When performing the above
work, remove the Shift Lever Unit.
10 - 1 REMOVING THE SHIFT LEVER
- Remove the 4 Tamperproof Screws to lift the Shift Lever Unit.
- Disconnect the Connector to remove the Shift Lever Unit.
- When reinstalling, follow the procedure opposite as when
removing. At this time, ensure that "DOWN" display
appears on the upper part as shown.
10 - 2 SWITCH REPLACEMENT
Method of replacement
- Disconnect the wiring Connector of the Switch to be replaced.
- Remove the 2 Tapping Screws (M3 X 16) to replace the Microswitch.
10 - 3 GREASING
Apply greasing once in 3 months to the specified portions.