METHOD OF V.R. ADJUSTMENT
- Loosen the 2 screws which secure the V.R. BRACKET, move the
V.R. BRACKETS and disengage the gears.
- Cause the V.R. value to match with the value obtained when
the pedal is released.
- Cause the gears to be engaged and secure the V.R. BRACKET.
At this time, be sure to obtain an appropriate backlash.
- Step on the pedal and check the V.R. value variation.
10-2 GREASING
Grease the gears and bearings once every 3 months as a standard.
11. 4 SPEED SHIFTER
In the test mode, if the shift lever input is found to be irregular,
replace the switch or adjust the switch installation position.
Also, grease the MECHA's shafts or sliding portions once every
3 months as a standard.
When performing the above work, remove the shift lever unit.
11-1 REMOVING THE SHIFTER
- Take off the 4 screws and remove SHIFT COVER A.
- Take out the 4 SPECIAL BOLTs and pull out the SHIFT LEVER
UNIT upward by paying careful attention so as not to cause damage
to the wiring.
- Disconnect CONNECTOR 6P and remove the shift lever unit.
