METHOD OF V.R. ADJUSTMENT
- Loosen the 2 screws which secure the V.R. BRACKET, move the
V.R. BRACKETS and detach the gears.
- Adjust the V.R. so that it is consistent with the value near
the centering position.
- Cause the gears to be engaged and secure the V.R. BRACKET.
At this time, make sure that an appropriate backlash is obtained.
- If the V.R. value is not appropriate when the steering wheel
is at the centering position, loosen the 2 screws which secure
the V.R. gear, turn the gear holder to make a fine adjustment
so that the V.R. value is within the allowable range.
- Check the V.R. value variations by fuming the handle.
9-2 GREASING
Once every 3 months, grease the gears, bearings, springs, and
cam & arm's sliding portions.
9-3 REMOVING THE CONTROL PANEL
For ordinary maintenance as mentioned above, it is not necessary
to remove the control panel. However, in the cases where passage
space cannot be provided behind the cabinets, the entire controls
to be replaced, or the monitor adjustments are to be made, remove
the control panel by using the following procedure:
- Take off a total of 4 tamperproof screws from the right-hand
side and left-hand side of the control panel's front portion.
- Take off 2 tamperproof screws underneath the control panel.
- Wiring connectors are connected in the control panel. Pull
out the control panel by paying careful attention so as not to
damage the wiring.
- Remove the wiring connectors.
When the control panel is removed, the monitor adjustment board
appears.