In the TEST mode, if the steering wheel V.R. value variations
are not within the allowable range, an adjustment of the V.R.
installation position or replacement of the V.R. are needed. Also,
apply grease to the steering wheel mechanism's shaft and sliding
portions once every 3 months.
To perform the above work, take off the 2 screws and remove BACK
LID A from the back of the cockpit.
CAUTION! Removing BACK LID A causes the monitor's high
tension portion to be exposed. When performing the following work.
Be very careful in this regard.
The upper side V.R. of the HANDLE MECHA is for the GAME BD.,
and the lower side one, for the DRIVE BD.
Check the value of the V.R. for the DRIVE BD. The appropriate
value of each V.R. is as follows:
To replace the V.R., after taking off the connector form the
V.R. to be replaced, take out the 2 screws which secure the VR
BRACKET, and remove the V.R. together with the bracket and gear.
After the replacement, check the V.R. value variations in the
test mode.
