---

[Table of Contents] [Previous Page] [Next Page]

---

13-3 MITSUBISHI PROJECTOR

MITSUBISHI PROJECTOR CONTROL PANEL

1. For the Convergence adjustment mode, press the test mode on/off key (12).
   
   
2. Ensure that "R" is displayed on the screen.
   
   
3. Make adjustment so as to cause the red cross pattern to match with the green cross pattern by using Left shift key (14), Right shift key (15), Lower shift key (16), and Upper shift key (17).
   
   
4. By using R/B shift key (13), cause the red adjustment "R" to shift to blue adjustment "B" and make sure that "B" is displayed on the screen.
   
   
5. In the same manner as in (3) above, cause the blue cross pattern to match with the green cross pattern.
   
   
6. After making adjustment, press the test mode on/off key (12) to cancel the Convergence adjustment mode.