[Table of Contents] [Previous Page] [Next Page]

13-2 HITACHI PROJECTOR

HITACHI PROJECTOR CONTROL PANEL
STATIC CONVERGENCE ADJUSTMENT

NOTE: Do not touch the right-hand side Convergence Adjustment SW. This SW is used for dynamic convergence adjustment which is rather complicated and the adjustment's visual effect is almost unnoticeable. Therefore, explanations thereof are not given in this

  1. Press the left-hand side Convergence Adjustment SW to cause the cross pattern to appear on to the screen.
  2. Use the remote control to make static adjustment.

Remote control [2], [5] Causes the red horizontal line to match with the green horizontal line.
Remote control [4], [6] Causes the red vertical line to match with the green vertical line.
Remote control [8], [11] Causes the blue horizontal line to match with the green horizontal line.
Remote control [10], [12] Causes the blue vertical line to match with the green vertical line.

  1. Press the left-hand side Convergence Adjustment SW. At this time, static adjustment results are written and the PTV screen will return to the original screen mode.