FIG. 6.11 POWER ON CHECK
Turning the AC unit's MAIN SW on will cause the machine to
start the POWER ON check automatically. The steering wheel turns
left and right, then returns to the centering position and stops.
In this check, the values of V. R. inside the control panel are
corrected. Until the check is finished (the steering wheel stops
automatically), do not touch the steering wheel or play the game.
If you do, the steering wheel reaction during the game (reaction
at the time of a course-out or crashing) can not be obtained correctly.
In a case of a strange reaction during the game, turn the power
on again from the beginning and complete the power-on check.
For communication play, the network check is performed after the
power is turned on and the on-screen display will show the check
mode. For details, refer to the COMMUNICATION MANUAL.
In the TEST MODE, ascertain that the assembly has been made
correctly and IC BD. is satisfactory (refer to Section 8). In
the test mode, perform the following test:
Selecting the MEMORY TEST on the test mode menu screen causes
the on-board memory to be tested automatically. The game board
is satisfactory if the display beside each IC No. shows GOOD.
