'STATIC CONVERGENCE ADJUSTMENT
MITSUBISHI PROJECTOR
MITSUBISHI PROJECTOR CONTROL PANEL
'
STATIC CONVERGENCE ADJUSTMENT
1. For the Convergence adjustment mode, press the test mode on/off key (12).
2. Ensure that "R" is displayed on the screen.
3. Make adjustments so as to cause the red cross pattern to match with the green cross pattern by using the Left Shift key (14), Right Shift key (15), Lower Shift key (16), and Upper Shift key (17).
4. By using R/B shift key (13), cause the red adjustment "R" to shift to the blue adjustment "B" and make sure that "B" is displayed on the screen.
5. In the same manner as in Step 3 above, cause the blue cross pattern to match with the green cross pattern.
6. After making adjustments, press the test mode on/off key (12) to cancel the Convergence adjustment mode.
STATIC CONVERGENCE ADJUSTMENT WITH REMOTE CONTROL
Although Remote Control Buttons
other than those specified below do not function even if pressed
during Convergence Adjustment, do not press them during adjustment
work so as to avoid causing malfunctioning. Operate the Remote
Control towards the PTV screen. If directed other than to the
PTV screen, the Remote Control does not function.BEFORE USING THE REMOTE CONTROL:
First make sure that the main SW on the Projector's control panel is ON (the LED adjacent to the main SW is lit).
The Remote Control has 2 different types. Depending on the type, the Adjustment procedure is different.
In case of REMOTE CONTROL (Part No. 200-5298):
1. For the Convergence Adjustment mode, press the test button (Figures 1-5 below). Ensure that "R" is displayed on the screen.
2. Make adjustment so as to cause the red cross pattern to match with the green cross pattern. When the red cross matches the green cross, the green cross turns yellow or white (Figures 2-3-4 below).
Use remote control buttons shown below to move the red cross as follows:
Button
(5) . . . . to the left.
(7) . . . . to the right.
(2) . . . . Upward.
(10) . . . Downward.
3. Use Remote Control button (6) to shift "R" to "B." Make sure that "B" is displayed on the screen. Each time Button (6) is pressed, red and blue adjustments are shifted.
4. In the same manner as in Step 2 above, cause the blue cross to match with the green cross. When the blue cross matches with the green cross, the green cross turns white.
5. After adjustment is made, press the test button (Figures 1-5 below) to cancel the Convergence Adjustment mode.
When 2 minutes or more elapses in the Convergence mode screen without taking any action, the on-screen adjustment mode will disappear.
In case of REMOTE CONTROL (Part No. 200-5532):
1. Press the TEST KEY to have the red line adjustment
screen appear.
2. Superimpose the red cross on the green cross at the center of the screen. Move the red cross to the left, right, up and down respectively. When the red cross is superimposed on the green cross, the green cross turns into yellow or white.
3. Press the R/B Key to have the blue line adjustment screen appear. Each time R/B Key is pressed, the red line and blue line will be alternated.
4. In the manner similar to 2. above, press each key to superimpose the blue cross on the green cross. When it is superimposed, the cross in the center will become white.
5. Press the TEST Key to exit from the adjustment mode.
During STATIC CONVERGENCE Adjustment Mode, if no action is taken within 5 minutes, the Adjustment Mode will be exited automatically.