PROJECTOR
Fine adjustments are stored in the projector. Pressing the fine adjustment switch (Convergence adjustment) results in entering the fine adjustments mode, and this may cause the stored fine adjustment to be changed. During work other than for adjustment, should you touch the fine adjustment switch by mistake, immediately turn off power by using the main switch and then turn it back on again. If any distortion or color deviation is found in the test mode, and adjustments are needed, use the specified adjustment knob or perform the adjustments by using the remote control. Note that projector models and makes may vary, and adjustment methods will differ dependent on the manufacturer.
The projector is subject to color deviation due to convergence deviation caused by geomagnetism at the installation location and peripheral magnetic field. After the installation of machine, and before commencing operation, check for convergence deviation and, if deviated, make necessary adjustments.
When the screen surface becomes dirty with dust, etc, clean it using a soft cloth such as gauze. When water and volatile chemicals such as benzine, thinner, etc, spill onto the the screen surface, it may be susceptible to damage, therefore, refrain from exposing the surface to these liquids. Also, since the screen surfaces are easily susceptible to damage from abrasion, avoid rubbing them with any hard materials or using a duster.