In order to prevent an electric shock and short circuit, be sure to turn power off before performing work by touching the interior parts of the product. Be careful so as not to damage wirings. Damaged wiring cancause an electric shock or short circuit accident.
When changing DIP SW setting, be sure to turn power off. DIP SW setting is not effective unless power is turned off and then on again after the setting changes. Be sure to turn power off before making setting changes for the above-mentioned safety purpose, also. In the case where Fixed Setting is designated, be sure to performDIP SW setting as specified in order to prevent malfunctioning.Among the DIP SW settings designated as Fixed Setting, some relateto factory check functioning and may not be appropriate for actualoperation.
By changing the setting of DIP SW on the Drive Control BD,Steering Wheel strength can be varied. However, use this methodonly in case Motor Power setting; it will work in theTest mode.