14-2 GREASING
When assembling, be sure to perform the work by multiple people. Depending on the assembly work, there are some cases in which performing the work by a single person may cause personal injury.
Be sure to use the designated grease. Using undesignated grease can cause parts damage.
Once every 3 months, apply greasing to the Bank Volume's gearmesh portion. Once every 6 months. apply greasing to the CenteringMechanism's Spring portion. For spray greasing, use GREASE MATE(PART No. 090-0066). To apply greasing to the Centering Mechanism'sSpring portion, remove the parts by following the procedure below.
1. Take out the 3 truss screws and remove the Side Step. (FIG.11.2)
2. Remove the 4 Hexagon Bolts which secure the Seat. (FIG.11.2)
3. Incline the seat by one person and disconnect the connectorunder the Seat by another person.
4. Take out the 4 screws and remove the Center Cover.
5. Apply greasing to the Centering Mechanism's Spring portion.(Photo 11. 2 a)
Remove Floor Center and apply greasing to the Bank's Volume'sgear mesh portion (Photo 11. 2 b)