[Previous Page] [Next Page] [Table of Contents]

6 - 4 INPUT TEST

When INPUT TEST is selected, the MONITOR will show the following, allowing you to watch the status of each switch. On the screen, periodically check the status of each switch.

1.> By pressing each switch, if the display on the right-hand side of the name of each switch changes to ON from OFF, the SW and the wiring connections are satisfactory.

2.> Open the COIN CHUTE DOOR and insert a coin from the COIN ENTRY to check the COIN CHUTE SW.

6 - 5 SOUND TEST

This eneables sound used in the game to be checked. Sound related memory and each speaker are checked. Press the SERVICE button to bring the arow to the desired sound item to be tested. Pressing the TEST button causes the desired test item to appear.

Each time the SERVICE button is pressed, the numeral displayed on the screen counts up and sound is emitted.

VR BANK INFO

V.R. SETTING PROCEDURE

While pressing the SHIFT-UP button, press the start button to select the desired change item. Release the button to make the selection effective.

With the SHIFT DOWN button pressed down, move the applicable device for shifting (throttle, brake and bank) fully within the applicable mobile range to set the value. When setting the Bank V.R., where the button is released will be the center position.

Upon finishing the setting change, press the TEST button to have the menu mode return to the screen.

To change V.R. securing position when replacing the V.R. etc., first secure the V.R. at ta position displaying the following values. Then, perform V.R. setting in the above mentioned procedure.

THROTTLE: 20 H min (without turning the THROTTLE GRIP)

BRAKE: 20 H min (without pulling the BRAKE LEVER)

BANK: 20 H min when inclined right