[Table of Contents] [Previous Page] [Next Page]
ADJUSTING HITACHI PROJECTORS

CAUTION! Never touch places other than those specified. Otherwise, hazardous electric shock or short-circuit can be caused.

There arc 2 types of HITACHI PROJECTORs. As shown below, the Control Panel layouts differ from each other. The lower layout allows Static Convergence to be adjusted merely by operating the Remote Control.

HITACHI PROJECTOR CONTROL PANEL





STATIC CONVERGENCE ADJUSTMENT

STOP: IMPORTANT! Do not touch Dynamic Convergence Adjustment Switch. Although dynamic Convergence adjustment is not needed for this product, should it be pressed by error, turn power off and then turn it back on again.

  1. Press the Static Convergence Adjustments SW which is on the Control Panel to cause the cross pattern to appear.



  3. Use the remote control to make static adjustment. For the operation of the Remote Controller, refer to the following pages.

  4. Press the Static Convergencc SW. At this time, static adjustment results are written and the PTV screen will return to the original screen mode.