Plug the AC cord going from the rear of the console into a
dedicated outlet.
Toggle the PTV AC switch.
Toggle the main AC switch, located at the lower center rear of
the console, to power up the machine and run a power on check.
In the power on check, the bike body banks left and right,
then returns to the center position. During this check, do not
touch the bike body. If you do, the body reaction (at the time
of a course out or crashing) will not be calibrated correctly.
The advertise mode is displayed at the same time the
power on check is finished. An error is displayed if any irregularity
is found during the check. In case of irregular reaction during
game play, turn the power off, and on again to perform the
power on check.
After the check is completed, the game is ready to play.
The service panel (See Figure) is located behind the Coin Mech
Door. The functions of each control on the service unit are described
below.