---

[Table of Contents] [Previous Page] [Next Page]

---

ADJUST LEG LEVELERS- BIKE CABINET

This cabinet has four (4) leg levelers. (See Figure) After the installation position has been determined, adjust the leg levelers so that they all contact the floor and the machine is level.

1. Adjust all four leg levelers by hand so they each make contact with the floor. With a box end wrench, continue to adjust levelers until the machine is level.
2. Since the bike cabinet is heavy, the leg levelers should be retracted when moving the machine over the floor.

INSTALL GUARD PIPE

Install the guide pipe to the rear base and secure with 4 hexagon bolts.
The guard pipe chain will be attached to the pipe. If it is disconnected, to reconnect, hook the chain on the guard pipe rings. Either the ends of the chain or optional hooks may be used to attach the chain to the rings.