By using the 4 hexagon bolts (black), secure the tower base
to the side of the rear base as shown.
Connect the connectors which come from the coin chute tower's
base with connectors inside the tower base, and fit the the coin
chute tower to the tower base.
By taking off the 2 truss screws, remove the lid for optic fiber
from the side of the front cabinet. Secure the tower support with
the 2 hexagon nuts from the inside of the front cabinet.
Open both of the upper and lower doors of the coin chute tower
and secure the coin chute tower with 4 hexagon bolts.
Move the PTV cabinet to the final installation location.
Adjust the four leg levelers on the PTV cabinet (See Figure) by
hand so that they all make contact with the floor. Continue to
adjust levelers until cabinet is level.
After the adjustments are complete, tighten the leg leveler nut
upward to secure the height of the leg leveler. (See Figure)
Since the PTV cabinet is heavy, retract its leg levelers when
moving the machine over the floor.
