12 - 2 MITSUBISHI MONITOR

For the Convergence adjustment mode, press the test mode on/off key. 12

Ensure that "R" is displayed on the screen.

Make adjustments so as to cause the red cross pattern to matchwith the green cross pattern by using Left shift key 14 , Rightshift key 15 , Lower shift key 16 , and Upper shift key 17 .

By using R/B shift key 13 , cause the red adjustment "R"to shift to blue adjustment "B" and make sure that "B"is displayed on the screen.

In the same manner as in 3 above, cause the blue cross patternto match with the green cross pattern.

After making adjustment, press the test mode on/off key 12to cancel the convergence adjustment mode.

STATIC CONVERGENCE ADJUSTMENT METHOD WITH REMOTE CONTROL

Although Remote Control Buttons other than those specifiedbelow do not function even if pressed during Convergence Adjustment,do not press them during adjustment work so as to avoid causingmalfunctioning.

Operate the Remote Control towards the PTV screen. If directedother than to the PTV screen, the Remote Control does not function.

BEFORE USING REMOTE CONTROL:

First make sure that the main SW on the Projector's controlpanel is ON (the LED adjacent to the main SW is lit).

The Remote Control has 2 different types. Depending on thetype, the Adjustment procedure is different.

For the Convergence Adjustment mode, press the test button.Ensure that "R" is displayed on the screen.

Make adjustment so as to cause the red cross pattern to matchwith the green cross pattern.

When the red cross matches the green cross, the green crossturns yellow or white.

Use remote control buttons shown below to move the red crossas follows:

Button to the left.......5

to the right................7

Upward....................2

Downward..............10

Use Remote Control button 6 to shift "R" to "B".Make sure that "B" is displayed on the screen. Eachtime Button 6 is pressed, red and blue adjustments are shifted.

In the same manner as in 2 above, cause the blue cross to matchthe green cross. When the blue cross matches the green cross,the green cross turns white.

After adjustment is made, press the test button to cancel theConvergence Adjustment mode.

*When 2 minutes or more elapses in the Convergence mode screenwithout taking any action, the on-screen adjustment mode willdisappear.

In case of REMOTE CONTROL (Part No. 200-5532):

Press the TEST KEY to have the red line adjustment screen appear.

Superimpose the red cross on the green cross at the centerof the screen.

Move the red cross to the left, right, up, and down respectivelywith the corresponding buttons of the remote control.

When the red cross is superimposed on the green cross, thegreen cross turns into yellow or white.

Press the R/B Key to have the blue line adjustment screen appear.Each time R/B Key is pressed, the red line and blue line willbe alternated.

In the manner similar to 2 above, press each key to superimposethe blue cross on the green cross. When it is superimposed, thecross in the center will become white.

Press the TEST KEY to exit from the adjustment mode.

During STATIC CONVERGENCE Adjustment Mode, if no action istaken within 5 minutes, the adjustment mode will be exited automatically.