FIGURE 53: UNDERSEAT CABINET LID REMOVAL
CLOSING THE UNDERSEAT CABINET
- Install the four anti-tamper Torx screws that secure the
front floorboard over the game board and power supply.
- Grasp the seat from the side, near the front of the base,
not along the top of the seat area.
- Tip the seat slowly up and forward until the bottom of the
seat rests on the underseat cabinet top edge (see Figures 52
and 53). Be careful not to catch or pinch your fingers between
the seat and the monitor cabinet.
- Lock the two locks on opposing sides of the underseat cabinet
(see Figure 53). The same key is used for both the locks on both
the left- and right-side underseat cabinets.
- Install the two #15 anti-tamper Torx screws (and washers)
that secure the seat to the underseat cabinet. They are located
just above the two locks on the opposing sides of the underseat
cabinet (see Figure 53).
- Plug the Indy 500 Twin game and turn on the power.