[Table of Contents] [Previous Page] [Next Page]

 

WARNING!
Make sure that all eight of the leg levelers are in contact with the floor (see Figure 9). If they are not, the cabinet may move and cause an accident.


ADJUST LEG LEVELERS
  1. Move the game cabinet to its final installation position. Be sure to allow room for the players to climb on the machine.
  2. Adjust the six outboard leg levelers (see Figure 7) on the cabinet by hand so they all make contact with the floor. Continue to adjust levelers until the machine is level and the casters are approximately 5 mm off of the floor (see Figure 8). If the casters are less than 5 mm off of the floor, the game may move during operation and become dangerous.
  3. After the adjustments are complete, tighten each leg leveler nut upward to secure the height of the leg leveler. (See Figure 9.)
  4. Attach the red joint plate (shipped in Crate 3) to the cabinet's two inner leg levelers (see Figures 7 and 10). Slide the notches in the joint plate over the levelers.
  5. Adjust the two inner leg levelers (see Figure 7) on the cabinet by hand so they both make contact with the floor. Continue to adjust levelers until the machine is level and the casters are approximately 5 mm off of the floor (see Figure 8). If the casters are less than 5 mm off of the floor, the game may move during operation and become dangerous.
  6. After the adjustments are complete, tighten both leg leveler nuts upward to secure the height of the leg leveler. (See Figure 9.)
  7. Since the cabinet is heavy, retract its leg levelers and roll on its casters (see Figure 9) when moving the machine over the floor. Do not move the assembled cabinet over uneven floors, or up or down steps and stairs. Detach the left and right-side cabinets from the Cash Box Tower before moving the cabinets over uneven areas.