[Table of Contents] [Previous Page] [Next Page]

 

INSTALL BILLBOARD
  1. Remove four 5/16 hex Billboard installation bolts from the top of both the left and right-side cabinets (8 total). Remove four 5/16 hex Billboard installation bolts from the back edge of the Billboard.
  2. Carefully lift the Billboard to the top of the cabinets (see Figure 5).
  3. Remove the three access screws from the front edge of the Billboard between the Billboard and Race Leader Marquee.
  4. Open the Billboard top section carefully.
  5. Attach the Billboard to the top of the game cabinet using four 5/16 hex bolts installed inside the front edge of the Billboard (see Figures 5 and 6). Do not tighten the bolts yet.
  6. Attach the Billboard to the top of the game cabinet using 4 5/16 hex bolts installed through the L-bracket along the back outside edge the Billboard (see Figures 5 and 6). Do not tighten the bolts yet.
  7. Align the Billboard and tighten all the bolts.
  8. From inside the Billboard, connect the three- and four-pin Molex connectors (one each) to provide power to the lamps.
  9. Reinstall the three access screws along the front edge of the Billboard to close the Billboard case.