---

[Table of Contents] [Previous Page] [Next Page]

---

13 - 4 ADJUSTING THE PROJECTOR

CAUTION! Never touch places other than those specified. Otherwise, hazardous electric shock or short-circuit can be caused.

Take out the 6 Truss Screws from Front Panel L of the front portion of the Front Cabinet, and the Projector's Control Panel appears.

PROJECTOR CONTROL PANEL

STATIC CONVERGENCE ADJUSTMENT

CAUTION! Do not touch the Dynamic Convergence Adjustment SW. Dynamic Convergence adjustment work is quite troublesome and the visual effect is expected to be negligible. As such, no explanation is given in this manual. Should the SW be pressed by mistake or otherwise, turn the power off and turn it back on again.

1. Press the Static Convergence Adjustment SW which is on the Control Panel to cause the cross pattern to appear.
2. Use the remote control to make static adjustment. For the operation of the Remote Controller, refer to the following pages.
3. Press the Static Convergence SW. At this time, static adjustment results are written and the PTV screen will return to the original screen mode.