1. ASSEMBLING THE CABINET
CAUTION! Since the Cabinet is moved during the assembly
work, be sure to proceed the work in such a place where the floor
is level and does not have step-like differences, with each of
the cabinet casters making contact with the surface.
- Secure the 2 L type Brackets to the Rear Cabinet with 2 Hexagon
Bolts (black) for each (bracket).
- Insert the Rear Cabinet's square pipe into the Front Cabinet's
square hole. At this time ensure that the pipe is inserted up
to the point approximately 10 cm. before the innermost end of
the hole.
- Take out the wiring (3P white connector, 2P black connector)
from the Rear Cabinet and connect the wiring to the Front Cabinet's
Connector Panel, and then ensure that the Rear Cabinet and the
Front Cabinet meet tightly without any clearance, by paying careful
attention so that the wiring is not caught in between.
- Firmly secure the L type Bracket secured as per (1) above
by using the 4 Hexagon Bolts.
