[Previous page][Next page][Table of Contents]

9 . COIN SELECTOR

HANDLING THE COIN JAM

If the coin is not rejected when the REJECT BUTTON is pressed, open the coin chute door and open the selector gate. After removing the jammed coin, put a normal coin in and check to see that the selector correctly functions.

 

The coin selector should be cleaned once every 3 months. When cleaning, follow the procedure below:

Turn the power for the machine OFF.

Open the coin chute door.

Open the gate and dust off by using a soft brush (made of wool, etc.).

Remove and cleen smears by using a soft cloth dipped in water or diluted chemical detergent and then squeezed dry.

Remove the CRADLE.

When removing the retaining ring(E-ring), be very careful so as not to bend the shaft.

Remove stain from the shaft and pillow portions by wiping off with a soft cloth, etc.

After wiping as per #5 above, further apply a dry cloth, etc. to cause the coin selector to dry completely.

Once a month, when performing the COIN SW TEST, simultaneously check the following:

Does the Coin Meter count satisfactorily?

Does the coin drop into the Cashbox correctly?

Is the coin rejected when inserted while keeping the REJECT BUTTON is pressed down?

 

CLEANING THE COIN SELECTOR

Never apply machine oil, etc. to the coin selector

After cleaning the Coin Selecting, Insert a regular coin in the normal working status and ensure that the Selector correctly functions.