[Table of Contents] [Previous Page] [Next Page]
BILLBOARD INSTALLATION
  1. Remove billboard form carton and remove upper holder and billboard plate. Remove billboard holders and hardware package from inside billboard case.

    Remove (8) 5/16 in hex bolts from top of cabinet.

  2. Attach billboard holders to rear of billboard case thru vertical slots with (4) 5/16 - 18 x 1" lg hex bolts and flat washers, lightly tighten.

  3. Mount billboard case across top of both cabinets and attach with (4) 5/16 - 18 x 1" lg hex bolts and flat washers thru mtg. holes. Do not tighten.

  4. Loosen billboard holders on rear of case and align over mtg. holes. Secure with (4) 5/16 -18 x 1" lg hex bolts and flat washers.

  5. Align billboard case and tighten all mtg. bolts.

  6. Connect the (3) billboard connectors. Two (blue & white) connectors on left side, 9 (blue) on right side. There is a extra white connector on Right side that is not used.

  7. Replace billboard plate and upper holder.