7. ASSEMBLING THE MACHINE
(1) ASSEMBLING YOUR DAYTONA USA TWIN GAME
To assemble your Daytona driving game locate the Left cabinet (side with on/off switch), Cash Box Tower, and Right side cabinet.
In the parts bag located in the cash box locate the Opto cable. This will be needed later, to connect together the opto connections on the rear of Cash Box Tower. The hardware needed to assemble your Daytona driving game has game threaded into the proper holes. This was done to insure the bolts thread properly into the T nuts in the cabinet.
At this time remove the rear cover of the Cash Box Tower.
Notice the wire harness taped to the sides of the cabinets and Cash Box Tower. On the wire harness connections Black is for Left side, Yellow is for Right side viewed from front. Locate Left side cabinet (on/off switch) and Cash Box Tower. (Fig 6.1A). Connect the 15, 4, and 2 position connectors together. At this time connect the Opto cable (without white label) to the Opto connection nearest to the Left side of cabinet (viewed from front). These Opto connections are in the rear of the Cash Box Tower.
You may elect not connect the connector at this time, but carefully push the connectors in the hole so they are still accessible form the outside of the cabinet.
There are 4 bolts in NON SLOTTED holes, on the side of the cabinet, the 2 on top under the ledge must be removed. The 2 on the bottom must be loosened about a 1/4 inch. Lift up the Cash Box Tower and using the 2 lower slotted holes on the bottom of the cash box slip them over the lower protruding bolts and slide the cash box into place. Open the coin door and install the 2 upper bolts through the cash box into the cabinet. Tightened all 4 bolts.
The Right side cabinet gets installed the same way as left side (Fig. 6.1B).
Don't forget to connect all the connectors described above. The opto cables with the white labels get connected together inside the rear Cash Box Tower. The 2 remaining opto cables get connected to the 2 external opto connectors on the rear of the Cash Box Tower. This is used for linking 2 or more games (Fig. 6.1C). Replace the Cash Box Tower rear cover.