In case a problem occurs, first check wiring connector connections.
|
PROBLEMS |
CAUSE |
COUNTERMEASURES |
|
|---|---|---|---|
| When the main power is not on, the machine is not activated. | The power is not ON. | Firmly insert the plug into the outlet. | |
| Incorrect power source/voltage. | Make sure that the power supply/voltage are correct. | ||
| AC Unit fuse blown off due to instantaneous overcurrent. | First remove the cause of overcurrent, then replace the fuse (see Sec. 6). | ||
| 514-5036-15000 FUSE 6.4 ØX 30 15000mA 125V |
AC100~120V AREA | ||
| 514-5037-8000 FUSE 6.4 ØX 30 8000rnA 250V |
AC220~240V AREA | ||
| PTV screen is blackened and the fluorescent lamp does not light up. | Power supply unit fuse blown off due to instantaneous overcurrent. | First remove the cause of overcurrent, then replace the fuse. | |
| 514-5036-10000 FUSE 6.4 ØX 30 10000mA 125V |
|||
| PTV screen is all blue. | Defective connections in between each board. | Make sure of correct connections in between each board. | |
| The color of image on PTV screen is incorrect. | Connector connections are defective. | Check to see if connector connections of RGB and SYNC are correct. | |
| Incorrect monitor adjustment. | Make appropriate adjustments (see Sec. 13). | ||
| PTV screen has a color deviation. | Affected by the periphery, such as other machines, location building's steel frames, etc. | Make convergence adjustments (see Sec. 13). | |
| Change installation direction/position. Move the other machines which cause the problem. | |||
| Sound is not emitted. | Sound volume adjustment is not correct. | Adjust the SWITCH UNIT's sound adjustment volume (control) (see Sec. 8). | |
| Malfunctioning of sound BD and memory. | Perform SOUND TEST (see Sec. 8). | ||
| Control panel and pedal not operable satisfactorily. | V. R. position deviated, or V. R malfunctioning. | Adjust or replace the V. R. (see Sec. 9 & 10). | |
| ADJUST GEAR's engagement is not correct. | Adjust the engagement of ADJUST GEAR (see Sec. 9 & 10). | ||
| SHIFT LEVER doesn't operate satisfactorily. | Switch position deviated, or switch malfunctioning. | Adjust or replace the Switch (see Sec. 11). | 509-5566 SW MICRO TYPE |
| Steering Wheel reaction strength is insufficient. | POWER ON CHECK not performed correctly. | First turn the power off and then turn it back on again. Complete the POWER ON CHECK. | |
| V. R. position deviated, or V. R. malfunctioning. | Adjust or replace the V. R. (see Sec. 9). | ||
| Reaction mecha's secular change. | Change DRIVE BD DIP SW setting (see Sec. 8 & 17). | ||
| Fluorescent lamp doesn't light up. | Fluorescent lamp needs replacement. | Replace the fluorescent lamp (see Sec. 14). | |