FIG. 10.1
In the test mode, if the ACCEL. & BRAKE V.R. value is not
within the allowable range, an adjustment of V.R. installation
position, or a replacement of V.R. is needed. Also, grease the
MECHA's shafts and sliding portions once every 3 months.
When performing the above work, take off the 4 truss screws and
remove the front cabi's front lid.
The ACCEL. & BRAKE MECHA can be seen by removing the front
lid. The ACCEL. V.R. is on the left- hand side and the BRAKE V.R.
is on the right-hand side of the MECHA. Check the V.R. value in
the test mode. The appropriate value of each V.R. is as follows:
| When released: | When stepped on: | ||
| ACCEL.: | Under 2 DH | <---> | Over D3H |
| BRAKE: | Under 2 DH | <---> | Over D3H |
To replace the V.R., after taking off the connector from the
V.R. to be replaced, take out the 2 screws which secure the VR
BRACKET, and remove the V.R. together with the bracket and gear.
After the replacement, check the V.R. value variations in the
test mode.
