FIG. 9.1
In the TEST mode, if the steering wheel V. R. value variations
are not within the allowable range, an adjustment of the V. R.
installation position or replacement of the V. R. are needed.
Also, apply grease to the steering wheel mechanism's shaft and
sliding portions once every 3 months. When carrying out the above
work, take off the 4 truss screws and remove the front cabi's
Front Lid Upper.
The upper side V. R. of the HANDLE MECHA is for the GAME BD.,
and the lower side one. for the DRIVE BD. Check the value of the
V. R. for the DRIVE BD. The appropriate value of each V. R. is
as follows:
| When the steering wheel is turned to or positioned at: |
Left | Centering position | Right |
| V. R. for the GAME BD.: | Under 2 DH | --7DH~83H --> | Over D3H |
| V. R. for the DRIVE BD.: | Under 2 DH | --7DH~83H --> | Over D3H |
To replace the V. R., after taking off the connector from the
V. R. to be replaced, take out the 2 screws which secure the VR
BRACKET, and remove the V. R. together with the bracket and gear.
After the replacement, check the V. R. value variations in the
test mode.
