3. CONNECTING THE CABINET AND PTV
Install the CONNECT TUBE in between PTV & Front Cabi and
make wiring connection. When performing the work, be sure to pay
careful attention so that the CONNECT TUBE wiring will not be
damaged by catching in between the door and the cabinet.
- Remove the PTV's SERVICE DOOR and front door's FRONT LID
LOWER (FIG. 6.2 and FIG. 6.7).
- Put the CONNECT TUBE's wiring connectors in the square hole
beside the front door and secure the JOINT BOX with 4 truss screws
by paying careful attention so that the connectors will not be
damaged.
- Connect the CONNECT TUBE's wiring connectors to the connector
panel inside the PTV. At this time, make sure that the wire color
(red, green, blue and brown) corresponds to the applicable one
of the connector panel's display (R. G. B. and SYNC terminals
(FIG. 6.8).
FIG. 6. 8
Also, note that the connector's insertion angle is predetermined.
When the connector is forcibly inserted in an incorrect direction,
it can be damaged. Therefore, ascertain the correct direction
before insertion. After insertion, turn the connector ring clockwise
to lock the connection.
- Put the connect tube wires into the square hole of the front
cabi's front lid lower and secure the joint box with 4 truss
screws. When fastening the screws, be careful so that the wires
will not be damaged. (FIG. 6.9)
FIG. 6. 9