[Table of Contents] [Previous Page] [Next Page]
  1. Insert the TV MASK from the underside in a manner as shown and secure it with a total of 6 screws.

  2. By using 2 screws for each, secure PANEL MOUNT BRACKET L & R to the front of the Projection Display. At this time, pay careful attention to the correct direction shown in which it is to be installed.

  3. Secure the FRONT PANEL to both PANEL MOUNT BRACKETs by using the 4 screws.

  4. Insert the BILLBOARD's connector into the connector on the Projection Display ceiling.

  5. Insert the BILLBOARD from the front in a manner as shown and secure it with 3 screws (FIG. 6.1).


FIG. 6. 2

[2] ASSEMBLING THE CABINET

PRECAUTIONS:
During assembly work, since the cabinets will be moved, perform the work by causing the casters to come into contact with the floor.

  1. Take out the six hexagon bolts (black) and remove the front cabi's STEP BOARD.

  2. Open the front cabi's COIN CHUTE DOOR.

  3. Put the wiring connectors (8P white) into the circular hole beside the coin chute door.

  4. Put the Optical Fiber cable through the front cabi's square pipe (FIG. 6.3).

CAUTION:
The optical fiber cable which is used for the communication play is inside the SERVICE DOOR beside the rear cabinet. When handling the optical fiber cable, be very careful. Note that excessive bending causes damage to it.


FIG. 6. 3