INITIAL SETUP
1. Setting up E2RESET
Note: All the data thathas already been set chnages to the adjustment data when setting E2RESET.
1. Press the "TEST" button on the remote hand unit. The built in cross-hair test pattern will appear.
2. Press the "1", "1", and "9" on the remote hand unit in that order to display the Options Menu.
3. Select the "E2RESET" pressing the "up" or "down" button on the remote hand unit and press "ENTER" to select "intial"
2. Setting up Self Auto Convergence
Note: Immediately after setting up "E2RESET"as above, set up the data for "Correction Coefficient" for SelfAutp Convergence.
1. Supply a standard signal.
2. Press the "TEST" button on the remote hand unit and then press the "1", "1", and "right" buttons to set to the Self Auto Convergence display.
3. Select an item pressing "up" or "down" button on the remote hand unit. Select the color using the "R/G" button.
4. Set the data in shown below pressing "left" or "right" button.
5. After finishing the setup; write the data into memory by pressing "ENTER".
6. Press the "TEST" button on the remote hand unit to teminate the adjustment mode.
