AIR DAMPER ADJUSTMENT
In this machine, the cylinders are equipped with air dampers to soften the impact created by the ride movements. If the cylinders amplitude of vibration or the impact is excessive, adjust the air dampers in the following procedure.
After turning power off, close
the main cock to start working. Starting work without closing
main cock can cause serious injury.
Make adjustments as specified.
Adjusting in a manner not specified can cause malfunctions and
parts damage.
Turn off power, and turn the circuit protector inside the front cabinet OFF.
Remove the rear lid from the mechanism base and close the main cock.
Remove the lid right.
Tighten the lock nut of the rear cylinder's adjuster fully to the bottom of the adjuster.
Loosen the A,B, C and D adjusters by 90 degrees from the fully tightened point.
Tighten the lock nut so the adjuster will not rotate.
After making adjustments, play the game, and check to see that the adjustments are made correctly.
In order to prevent an electric
shock, be sure to turn power off before performing work and touching
interior parts of the machine.
Be careful so as not to damage wiring and cause an electric shock or short circuit.
Do not expose the game board
without good reason. In this product, setting changes are made
during the test mode. The game board need not be operated. Use
the game board as is, with the settings made at the time of shipment.TAKING OUT THE SHIELD CASE ASSEMBLY
When a problem occurs on the game board, remove the shield case assembly for return to the factory by using the following procedure:
Turn the main switch off.
The shield case is inside the cabinet, accessible from the locked door on the right side.
Remove two tamperproof screws using the tool provided to you. Unlock the side door and remove.
Remove connectors to filter board on shield case assembly and remove 4 wood screws that secure the shield case to the cabinet. Remove the shield case from the cabinet, and exercise care not to drop the shield case when doing so.
Place shield case securely in the re-useable box provided to you with the game.
Do not open the shield case for
any reason. Any inspection or repairs to the game board must be
performed at the Sega facility only. Removing the game board from
the shield case may cause your factory warranty to be voided.