[Table of Contents] [Previous Page] [Next Page]

EXTERNAL AIR COMPRESSOR UNIT


 

The Sega Wave Runner game is equipped with an external, permanently lubricated air compressor unit, which is housed in a separate black box.

The black compressor box is not attached to any portion of the game. The unit may be located within 25 feet of the game, and no more than 6 feet from the electrical outlet.


The Air Compressor unit must have excess water drained from the air tank on a daily basis.

 

For specifications and service information, refer to the attached EXTERNAL AIR COMPRESSOR UNIT SUPPLEMENT to this OWNERS MANUAL.

TO INSTALL THE EXTERNAL COMPRESSOR UNIT

Remove the 6 screws which secure the connection panel to the base of the ride.

Lifting the panel, locate the air line hole, and the quick disconnect connector inside the game. Locate the black compressor box and open the key-locked door. Pull air line hose out of the black compressor box and route it to the air line hole in the game.

Connect the air line hose quick connector to the quick connector in the game.

Verify that the connection is secure and tight.

Replace the panel and tighten all screws.