POWER ON
When the power is first turned
on, the ride moves. To prevent injury, first check for safety
in the periphery of the ride, and then turn power on.
If ERROR is displayed in the Advertise mode, do not operate the machine. Operating the machine when ERROR is displayed can cause a serious safety hazard.
During intitialization settings,
do not touch the ride portion. Wait until the intialization settings
finish automatically. Touching the ride during initialization
settings can cause inaccurate settings.
Turn the AC Unit Main SW ON to turn on the machine's power supply. At the same time the power is turned on for the power supply, the machine starts the initialization setting movements and displays the screen on which the setting is being made. Do not touch the Ride until the initialization setting movements are automatically finished.
Approximately 5 seconds after the power is turned on, the compressor starts to operate. If the pressure inside the tank is insufficient, it takes several minutes to attain the preset pressure. At the time of installation assembly, it takes approximately 3 minutes. When operation is being continued, it takes approximately one and half minutes due to the prestress.
The ride portion secures the left/ right inclination to the center.
The front of the ride portion lowers.
The front of the ride portion is raised.
The front of the ride portion moves to the intermediate position in the up/down movement.
The front of the ride portion lowers.
The compressor stops.
After finishing the initialization setting movements, the ADVERTISE mode returns. During the setting movements, if any irregularity, malfunctioning, etc. of the moving mechanism are found, ERROR display is shown on the lower part of the ADVERTISE mode screen. In this case, the machine will not operate satisfactorily. Please contact the Distributor, etc. where this product was purchased from. In the case where several machines are connected, network check is performed after initialization settings are finished, and the screen displays to the effect that the check is being conducted. After checking, the ADVERTISE mode returns. Normally the network checking takes 1~3 minutes. If there is any irregularity in the communication connection, check screen display will continue.