ASSEMBLING THE CABINET
Mount the Front Cabinet on the PTV Base.
By using the 4 accessory wires, perform wiring connection between PTV and the Cabinet.
Insert the wiring connectors each of which wire covering is red, green, and blue to the corresponding one of R. G. B. terminals as per connector panel display inside the PTV, and insert the remaining wire connector to the SYNC terminal.
At this time, incline the Cabinet to connect the connectors by pulling them from the cabinet's rear hole.
The Connector's insertion angle is predetermined. Inserting the Connector in a forcible manner will damage the Connector. Check for the correct inserting direction and then insert the Connector.
After the insertion of Connector, turn the Connector's Ring to the right to lock the connection.
The PTV connector panel has 3p white connector in
addition to the Connectors displayed as R. G. B. and SYNC. Connect
the wiring from the power supply unit to the 3p white.
Connect the opposite side of the wiring (which is connected to the terminal displayed as R. G. B. and SYNC) to the corresponding R. G. B. and SYNC terminals of the VPM Buffer BD in the Front Cabinet. By turning the Connector Ring to the right, lock the connection for the 4 Connectors inserted to the Board.
Tightly join the PTV and the cabinet by using care so as not to damage the wiring.
By using the 8 screws, connect the PTV Base, PTV, and the cabinet.
