[Table of Contents] [Previous Page] [Next Page]

2. PRECAUTIONS CONCERNING INSTALLATION LOCATION


This product is an indoor game machine. Do not install it outside. Even indoors, avoid installing in places mentioned below so as not to cause a fire, electric shock, injury and or malfunctioning.

Places subject to rain or water leakage, or places subjectto high humidity in the proximity of an indoor swimming pool andor shower, etc. Piaces subject to direct sunlight, or places subjectto high temperatures in the proximity of heating units, etc. Placesfilled with inflammable gas or vicinity of highly inflammable/volatilechemicals or hazardous matter. Dusty places. Sloped surfaces Placessubject to any type of violent impact. Vicinity of anti-disasterfacilities such as fire exits and fire extinguishers. The operating(ambient) temperature range is from 5°C to 40°C. Onlyin the case a projector is employed, the temperature range isfrom 5C to30C.


LIMITATIONS OF USAGE REQUIREMENTS


Be sure to check the Electrical Specifications.

Ensure that this product is compatible with the location'spower supply, voltage and frequency requirements.

A plate describing Electrical Specifications is attached tothe product.

Non-compliance with the Electric Specifications can cause afire and electric shock.

This product requires the Breaker and Earth Mechanisms as partof the location facilities. Using them in a manner not independentcan cause a fire and electric shock.

Ensure that the indoor wiring for the power supply is ratedat 15A or higher (AC single phase 100~120V), and 7A or higher(AC 220~240V). Non-compliance with the Electrical Specificationscan cause a fire and electric shock.

Be sure to independently use the power supply equipped withthe Earth Leakage Breaker. Using a power supply without the EarthLeakage Breaker can cause an outbreak of fire when earth leakageoccurs.

Putting many loads on one electrical outlet can cause generationof heat and a fire resulting from overload.

When using an extension cord, ensure that the cord is ratedat 15A or higher (AC 100~120V area) and 7A or higher (AC 220~240Varea). Using a cord rated lower than the specified rating cancause a fire and electric shock.



Note that for transporting the machine into the location's building, the minimum necessary dimensions of the opening (of doors, etc.) are 1.2m (W) and 1.2m(H).

For the operation of this machine, secure a minimum area of1.5m (W)X 3m (D)

Provide sufficient space so as to allow this product's ventilationfan to function efficiently. To avoid machine malfunctioning,do not turn off power for the fan, and do not place any obstaclesnear the ventilation opening.