1) For the Convergence adjustment mode, press the test mode on/off key (12).
2) Ensure that "R" is displayed on the screen.
3) Make adjustment so as to cause the red cross pattem to match with the green cross pattern by using Left Shift key (14), Right shift key (15), Lower shift key (16) and Upper shift key (17).
4) By using R/B shift key (13), cause the red adjustment "R" to shift to blue adjustment "B" and make sure that "B" is displayed on the screen.
5) In the same manner as in 3) above, cause the blue cross pattern to match with the green cross pattern.
6) After making adjustment, press the test mode on/off key (12) to cancel the Convergence adjustment mode.
BEFORE USING THE REMOTE CONTROL:
First make sure that the main SW on the Projector's control panel is ON (the LED adjacent to the main SW is lit).
The Remote Control has 2 different types. Depending on the type, the Adjustment procedure is different.
In case of REMOTE CONTROL (Part No. 200-5298):
1) For the Convergence Adjustment mode, press the test button (Figures 1 · 5 below). Ensure that "R" is displayed on the screen.
2) Make adjustment so as to cause the red cross pattern to match with the green cross pattern. When the red cross matches the green cross, the green cross turns yellow or white (Figures 2 · 3 · 4 below).
Use remote control buttons shown below to move the red cross as follows: Button:
3) Use Remote Control button (6) to shift "R" to "B." Make sure that "B" is displayed on the screen. Each time Button (6) is pressed, red and blue adjustments are shifted.
4) In the same manner as in 2) above, cause the blue cross to match with the green cross. When the blue cross matches with the green cross, the green cross turns white.
5) After adjustment is made, press the test button (Figures 1 · 5 below) to cancel the Convergence Adjustment mode.
