Input Test

[Table of Contents] [Previous Page] [Next Page]

9-5 INPUT TEST

When INPUT TEST is selected, the following screen appears on the monitor. The screen allows the status of each SW and the value of each V.R. of the cabinet to be viewed. On this screen, periodically check the status of each switch & V.R.

By pressing each switch, if the display on the right-hand side of the name of each switch changes to ON from OFF, the SW and the wiring connections are satisfactory.
To check the Coin SW of "COIN #X", open the Coin Chute Door and insert a coin into the Coin Inlet.
To check the "FOOT SENSOR", step on the Foot Controller. The Foot Controller is satisfactory if it is "ON" when stepped on and if it is "OFF" when the foot is out of place.
Press the Test button, or simultaneously press the Start button and View button to have the Menu mode return.

The standard values for adjusting SWING V. R. are as follows:

The adjustment is satisfactory if the V. R. values vary in the smooth natural manner when the Foot Controller is operated, and if the values are within the following range when no force is applied.

If EDGING (INCLINING) V. R. values are within the following range when the Foot Controller is fully inclined both in right and left directions, the adjustment is satisfactory.

SWING: 7 0~8 F H
(Centering position)
INCLINING: 2 0 ~ D 0 H

If V. R. values are not within the range specified above, operation can not be performed satisfactorily. By referring to Section 10, adjust or replace the Volume.