[Previous Page] [Next Page] [Table of Contents]

COMMUNICATION PLAY CONT''D

2. Attach the CONNECTOR 22 to the both ends of FLEX TUBE, and assemble the PROTECT TUBE. First, disassemble CONNECTOR 22.

3. First pass the plastic nut through the flex tube. Otherwise, the following work can not be performed and therefore, be very careful of this point.

4. Install the holder and then the "insert' for both ends of the flex tube by turning them as in bolts and nuts.

5. Tighten the plastic nut to the connector. At this time, pass the optic fiber cable through the flex tube ahead of time so as to allow the following work to be performed easily.

6. Install the PROTECT TUBE into the HOLE PLATE (TTR-0015) HOLE. Insert the connector into the HOLE PLATE HOLE, put seal washer through and fasten the metal nut.