[Previous Page] [Next Page] [Table of Contents]


 

[2.] ASSEMBLING THE CABINET

During assembling work, the cabinet is moved. When assembling, ensure that casters of each are in contact with the floor.

 


 1.> Secure the two L type Brackets to the Rear Base by using 2 hexagon bolts (black) for each Bracket.

 

2.> Insert the Rear Base's square pipes into the Front Cabinet's square holes. At this time pay careful attention so that the Front Cabinet's wirings are not caught.

 

3.> Remove the 2 Truss Screws to open the Hole Lid on the upperpart face of the Rear Base shown.

 

4.> Connect a total of six connectors inside the Rear Base.

 

5.> By using the 4 Hexagon Bolts (black), securely fasten the L type Brackets secured as per 1 above.

 

6.> Connect Front Cabinet wirings to the Connector Panel inside previously assembled PTV. At this time make sure that the wire color (red, green, blue, and the remaining color) corresponds with the applicable symbol of the Connector Panel's Display (R.G.B. and SYNC terminals.)

Also, note that the connector's insertion angle is predetermined. The connector can be damaged if forcibly inserted in an incorrect direction. Therefore, ascertain the correct direction before insertion. After insertion, turn the connector ring clockwise to lock the connection.

7.> Fit the Cabinet along the PTV's Guide Bracket.

 

8.> Open the Front Cabinet's Service Lid by taking out the 2 screws and using the Master Key, and secure the PTV and the Cabinet with 2 Truss Screws.

 

9.> Reinstall the previously removed Hole Lid and Service Lid.