[Previous Page] [Next Page] [Table of Contents]

9 - 2 MITSUBISHI PROJECTOR

1. For Convergence adjustment mode, press the test mode on/off key. #12

2. Ensure that "R" is displayed on the screen.

3. Make adjustments so as to cause the red cross pattern to match with the green cross pattern by using the Left shift key #14, Right shift key #15, Lower shift key #16, and Upper shift key #17.

4. By using R/B shift key #13, cause the red adjustment "R" to shift to blue adjustment "B" and make sure that "B" is displayed on the screen.

5. In the same manner as in #3 above, cause the blue cross pattern to match with the green cross pattern.

6. After making adjustment, press the test mode on/off key #12 to cancel convergence adjustment mode.

Although Remote Control Buttons other than those specified below do not function even if pressed during Convergence Adjustment, do not press them during adjustment work so as to avoid causing malfunctioning. Operate the Remote Control towards the PTV screen. If directed other than to the PTV screen, the Remote Control does not function.

BEFORE USING REMOTE CONTROL:

First make sure that the main SW on the Projector's control panel is ON (the LED adjacent to the main SW is lit).

The remote control has 2 different types. Depending on the type, the adjustment procedure is different.

In Case of REMOTE CONTROL (PART No. 200-5298):

1. For the Convergence Adjustment mode, press the test button. Ensure that "R" is displayed on the screen.

2. Make adjustment so as to cause the red cross pattern to match the green cross pattern. When the red cross pattern matches the green cross pattern, the green cross turns yellow or white.

Use Remote Control Buttons shown below to move the red cross as follows:

Button #5 - to the Left

Button #7 - to the Right

Button #2 - Upward

Button #10 - Downward

3. Use remote control button #6 to shift "R" to "B". make sure that "B" is displayed on the screen. Each time button #6 is pressed, red and blue adjustments are shifted.

4. In the same manner as in #2 above, cause the blue cross to match the green cross. When the blue cross matches the green cross the green cross turns white.

5. After adjustment is made, press the test button to cancel the Convergence Adjustment Mode. *When 2 minutes or more elapses in the Convergence Adjustment mode screen without taking any action, the on-screen adjustment mode will disappear.

In Case of REMOTE CONTROL (PART No. 200-5532):

1. Press the TEST KEY to have the red line adjustment screen appear.

2. Superimpose the red cross on the green cross at the center of the screen. Move the red cross to the left, right, up, and down respectively with the corresponding buttons of the remote control. When the red cross is superimposed on the green cross, the green cross turns into yellow or white.

3. Press the R/B Key to have the blue line adjustment screen to appear. Each time R/B Key is pressed, the red line and the blue line will be alternated.

4. In a manner similar to #2 above, press each key to superimpose the blue cross on the green cross. When it is superimposed, the cross in the center will become white.

5. Press the TEST KEY to exit from the adjustment mode. During STATIC CONVERGENCE Adjustment Mode, if no action is taken within 5 minutes, the adjustment mode will be exited automatically.