[Previous Page] [Next Page] [Table of Contents]

 9 - 2 ADJUSTING HITACHI PROJECTORS

NOTE: THIS PAGE HAS MANY GRAPHICS AND MAY TAKE A MOMENT TO LOAD PLEASE BE PATIENT.

Never touch places other than those specified. Otherwise, hazardous electric shock or short circuit can be caused.

There are 2 types of HITACHI PROJECTORS. As shown below, the Control's Panel's layout differs from each other. The lower layout allows Static Convergence to be adjusted merely by operating the Remote Control.

Do not touch Dynamic Convergence Adjustment Switch. Although dynamic Convergence adjustment is not needed for this product, should it be pressed by error, turn power off and then turn it back on again.

Press the Static Convergence Adjustment SW which is on the Control Panel to cause the cross pattern to appear.

Use the Remote control to make static adjustment. For the operation of the Remote Controller, refer to the following pages.

Press the Static Convergence SW. At this time, static adjustment results ar ewritten and the PTV screen will return to the original screen code.