[Previous Page] [Next Page] [Table of Contents]

7 -5 BIKE MECHA

When replacing the VOLUME be sure to turn power off. Working without turning power off can cause electric shock or short circuit accident.

1.> Take out the 4 hexagonal socket head bolts to remove the Fuel Cap.

2.> Take out a total of 3 bolts which secure the Tank to remove the tank.

3.> Take out the 2 screws and remove the Wire Clamp.

4.> Take out the 4 screws and remove the Volume Cover.

5.> Take out the 2 screws and Connector to replace the V.R.

6.> After V.R. replacement, make adjustment of gear mesh in the manner so that when the bike is banked, the V.R. shaft does not rotate beyond the shaft's predetermined rotation range.

7.> After the adjustment is finished, install Tank, and Fuel Cap.

8.> After assembly, perform V.R. setting in the Test Mode.Replace the bike's bank angle V.R. in the following procedure.