[Previous Page] [Next Page] [Table of Contents]

7 - 2 THROTTLE/BRAKE V.R. REPLACEMENT

When replacing the VOLUME, be sure to turn power off. Performing replacement work without turning power off can cause electric shock or short circuit accident

REPLACEMENT PROCEDURE

For V.R. replacement, turn the V.R. shaft to the periphery of V.R. shaft angle in which the V.R. value is the minimum, engage the Gears and secure the V.R. Bracket. At this time, make sure that the throttle and brake are not supplied respectively to the Grip and Brake Lever. Game is playable satisfactorily if the V.R. Shaft rotates without any problem within the mobile range of the Grip and the Lever.

Take out the 2 screws which secure the V.R. Bracket to remove the Bracket from the Handle Unit.

To remove the PINION GEAR, loosen the 2 set screws of the Pinion Gear attached to the Shaft of the V.R. to be replaced.

Take out Nut A from the V.R. Shaft to remove the V.R. from the Bracket.

After replacement, assemble in the procedure oppisite to the above.

In the test mode, perform V.R. setting.